Jump to content
Product Design Forums
Sign in to follow this  
Guest Tomislavp4

Help With Lofting In Solidworks

Recommended Posts

Guest Tomislavp4

Hi guys, this is my first post here :)

I have a litle problem and after searching for some good forums I found this one....

 

anyway, to the problem

this is the sketch

[img:150:70]http://img222.imageshack.us/img222/7984/modelev7.th.jpg[/img]

 

and when I try to make a loft it´s saying "cannot knit sheets together"

[img:150:77]http://img222.imageshack.us/img222/9392/errorul5.th.jpg[/img]

 

Can someone explain why is it so, and tell my how to solve it? Thanks

Share this post


Link to post
Share on other sites

Dear Tom

 

I replicated almost the same sketches and had no problem.

I wonder, why you have two "open loops" for the profiles. Is the upper Sketch A COMBINATION OF ENTITIES?, or just one spline.

 

Should be nice if you put the SW file to check. (I am not sure if the Sketches are in a plane or are 3DSk)

 

 

post-4562-1192578059.jpg

 

Ciao

Share this post


Link to post
Share on other sites

you probably don't want the globing effect to occor at the ends. You might try to create your surface using the new in 2007 tool called boundary surface. You might also try to create a full four part boundary.

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

×

Important Information

By using this site, you agree to our Terms of Use.