3 replies to this topic

[nalsur]

please help how to make loft for handle of jar
i try but it not same like the picture

source file: http://dl.dropbox.co...18/Jar_1.SLDPRT

tq
 IMG_20120722_132403.jpg   38.52K   2 downloads
 IMG_20120722_132413.jpg   40.09K   4 downloads
 IMG_20120722_132434.jpg   36.24K   4 downloads
 IMG_20120722_132452.jpg   38.22K   2 downloads

[muadib3d]

I can not edit SW files(Creo 1.0/2.0 user), however I can guide you which approach I would take if I were up to make it in Creo:

so in general main geometry should be done as revolve. Handle is a loft - so in Creo I would use Sweep tool first to loft section of handle along two trajectories displayed in red and green in attached picture. To me red trajectory would play primary role, and yes, in Creo this - sequence of trajectories - does have an impact.

So, what would become critical issue to solve(Sweep tool will fail trying to acomplish this) is 3 sided boundary surface which should be solved in appropriate way(check forum).

In Creo I would use Boundary Blend to create first primary 4 sided surface, trim it back and make final 4 sided surface. However as far as I am aware SW offers such tools(to solve n-sided boundary surfaces issues) by default.

Hope it helps.

 IMG_20120722_132434.jpg   89.8K   0 downloads

[nalsur]

muadib3d:

here parasolid files : http://dl.dropbox.co...1_parasolid.x_b

[muadib3d]

neither sldrp nor x_b can be retrived by me. STEP fits the best.